![]() Where risk assessment shows air-purifying respirators are appropriate use a full-face particle respirator type N100 (US) or type P3 (EN 143) respirator cartridges as a backup to engineering controls. Wash and dry hands.Ĭomplete suit protecting against chemicals, The type of protective equipment must be selected according to the concentration and amount of the dangerous substance at the specific workplace. Dispose of contaminated gloves after use in accordance with applicable laws and good laboratory practices. Technique (without touching glove's outer surface) to avoid skin contact with this product. Wash hands before breaks and at the end of workday.įace shield and safety glasses Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU). Handle in accordance with good industrial hygiene and safety practice. Keep container tightly closed in a dry and well-ventilated place.Īpart from the uses mentioned in section 1 no other specific uses are stipulated Provide appropriate exhaust ventilation at places where dust is formed.Ĭonditions for safe storage, including any incompatibilities Keep in suitable, closed containers for disposal.Īvoid contact with skin and eyes. Pick up and arrange disposal without creating dust. Methods and materials for containment and cleaning up Prevent further leakage or spillage if safe to do so. Personal precautions, protective equipment and emergency procedures Wear self-contained breathing apparatus for firefighting if necessary. Nickel/nickel oxides, Lithium oxides, Cobalt/cobalt oxides, Manganese/manganese oxides Special hazards arising from the substance or mixture Use water spray, alcohol-resistant foam, dry chemical or carbon dioxide. Indication of any immediate medical attention and special treatment needed ![]() The most important known symptoms and effects are described in the labelling (see section 2) and/or in section 11 Most important symptoms and effects, both acute and delayed Never give anything by mouth to an unconscious person. If not breathing, give artificial respiration. If breathed in, move person into fresh air. Show this safety data sheet to the doctor in attendance. COMPOSITION/INFORMATION ON INGREDIENTSĬonsult a physician. Hazards not otherwise classified (HNOC) or not covered by GHS-none If skin irritation or rash occurs: Get medical advice/ attention.ĭispose of contents/ container to an approved waste disposal plant. Specific treatment (see supplemental first aid instructions on this label). ![]() IF exposed or concerned: Get medical advice/ attention. IF ON SKIN: Wash with plenty of soap and water. Thin Film Deposition & Evaporation Materialsĭo not handle until all safety precautions have been read and understood.Īvoid breathing dust/ fume/ gas/ mist/ Vapors/ spray.Ĭontaminated work clothing should not be allowed out of the workplace.Additive Manufacturing & 3D Printing Materials.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |